DXF IMPORT
Overview
The DXFCVT converter is fully integrated into the layout module and is driven through the Import DXF tool on the File menu. It facilitates the import of mechanical data in DXF format, and we envisage it being used in situations where a board needs to be fitted into an existing mechanical design. It could also be used to import other graphics such as company logos.
The conversion process is as follows:
- Generate the DXF file from your mechanical CAD application. This should, if possible, be a 2D drawing. Proteus cannot handle 3D data and the converter thus ignores all z co-ordinates in the DXF file so 'flattening' 3D drawings to two dimensions.
- Decide which layout layer the data is to land on. Each import places its graphics on a single layout layer, which you choose from the PCB Layout Layer combo on the DXF Import dialogue form. You can combine any number of layers from the DXF file onto that one layout layer by ticking them in the DXF Layer(s) list.
- Where the DXF file carries data that belongs on more than one layout layer, run the import once for each destination layer, ticking only the DXF layers that belong there.
The DXF importer will automatically determine the correct units, provided that they are specified within the input file.
You should appreciate that Autocad (the application around which the DXF format was based) supports much more powerful mechanical drafting than that offered by Proteus. Thus some entities in a DXF file are ignored by DXFCVT, and others are approximated. However, for the purpose of displaying simple cabinet internals and the like inside Proteus, DXFCVT is quite adequate to the task.
Keep the imported DXF data to the minimum, essential information, particularly if you want to convert it to copper objects during import. Splitting the job into several smaller imports, each onto its own layout layer, gives you the most control over the result.
See Also:
See the Limitations section for specific information on the limitations of the DXFCVT converter.